Disable swappingedit

Most operating systems try to use as much memory as possible for file system caches and eagerly swap out unused application memory. This can result in parts of the JVM heap or even its executable pages being swapped out to disk.

Swapping is very bad for performance, for node stability, and should be avoided at all costs. It can cause garbage collections to last for minutes instead of milliseconds and can cause nodes to respond slowly or even to disconnect from the cluster. In a resilient distributed system, it’s more effective to let the operating system kill the node.

There are three approaches to disabling swapping. The preferred option is to completely disable swap. If this is not an option, whether or not to prefer minimizing swappiness versus memory locking is dependent on your environment.

Disable all swap filesedit

Usually Elasticsearch is the only service running on a box, and its memory usage is controlled by the JVM options. There should be no need to have swap enabled.

On Linux systems, you can disable swap temporarily by running:

sudo swapoff -a

This doesn’t require a restart of Elasticsearch.

To disable it permanently, you will need to edit the /etc/fstab file and comment out any lines that contain the word swap.

On Windows, the equivalent can be achieved by disabling the paging file entirely via System Properties → Advanced → Performance → Advanced → Virtual memory.

Configure swappinessedit

Another option available on Linux systems is to ensure that the sysctl value vm.swappiness is set to 1. This reduces the kernel’s tendency to swap and should not lead to swapping under normal circumstances, while still allowing the whole system to swap in emergency conditions.

Enable bootstrap.memory_lockedit

Another option is to use mlockall on Linux/Unix systems, or VirtualLock on Windows, to try to lock the process address space into RAM, preventing any Elasticsearch memory from being swapped out. This can be done, by adding this line to the config/elasticsearch.yml file:

bootstrap.memory_lock: true

mlockall might cause the JVM or shell session to exit if it tries to allocate more memory than is available!

After starting Elasticsearch, you can see whether this setting was applied successfully by checking the value of mlockall in the output from this request:

GET _nodes?filter_path=**.mlockall

If you see that mlockall is false, then it means that the mlockall request has failed. You will also see a line with more information in the logs with the words Unable to lock JVM Memory.

The most probable reason, on Linux/Unix systems, is that the user running Elasticsearch doesn’t have permission to lock memory. This can be granted as follows:

.zip and .tar.gz
Set ulimit -l unlimited as root before starting Elasticsearch, or set memlock to unlimited in /etc/security/limits.conf.
RPM and Debian
Set MAX_LOCKED_MEMORY to unlimited in the system configuration file (or see below for systems using systemd).
Systems using systemd
Set LimitMEMLOCK to infinity in the systemd configuration.

Another possible reason why mlockall can fail is that the JNA temporary directory (usually a sub-directory of /tmp) is mounted with the noexec option. This can be solved by specifying a new temporary directory for JNA using the ES_JAVA_OPTS environment variable:

export ES_JAVA_OPTS="$ES_JAVA_OPTS -Djna.tmpdir=<path>"
./bin/elasticsearch

or setting this JVM flag in the jvm.options configuration file.