The tribes feature allows a tribe node to act as a federated client across multiple clusters.
The tribe node works by retrieving the cluster state from all connected clusters and merging them into a global cluster state. With this information at hand, it is able to perform read and write operations against the nodes in all clusters as if they were local. Note that a tribe node needs to be able to connect to each single node in every configured cluster.
elasticsearch.yml config file for a tribe node just needs to list the
clusters that should be joined, for instance:
The example above configures connections to two clusters, name
respectively. The tribe node will create a node client to
connect each cluster using unicast discovery by default. Any
other settings for the connection can be configured under
cluster.name in the example.
The merged global cluster state means that almost all operations work in the same way as a single cluster: distributed search, suggest, percolation, indexing, etc.
However, there are a few exceptions:
- The merged view cannot handle indices with the same name in multiple clusters. By default it will pick one of them, see later for on_conflict options.
- Master level read operations (eg Cluster State, Cluster Health) will automatically execute with a local flag set to true since there is no master.
- Master level write operations (eg Create Index) are not allowed. These should be performed on a single cluster.
The tribe node can be configured to block all write operations and all metadata operations with:
tribe: blocks: write: true metadata: true
The tribe node can also configure blocks on selected indices:
tribe: blocks: write.indices: hk*,ldn* metadata.indices: hk*,ldn*
When there is a conflict and multiple clusters hold the same index, by default
the tribe node will pick one of them. This can be configured using the
setting. It defaults to
any, but can be set to
drop (drop indices that have
a conflict), or
prefer_[tribeName] to prefer the index from a specific tribe.
Tribe node settingsedit
The tribe node starts a node client for each listed cluster. The following configuration options are passed down from the tribe node to each node client:
node.name(used to derive the
node.namefor each node client)
Almost any setting (except for
path.*) may be configured at the node client
level itself, in which case it will override any passed through setting from
the tribe node. Settings you may want to set at the node client level