Transport Clientedit

The TransportClient connects remotely to an Elasticsearch cluster using the transport module. It does not join the cluster, but simply gets one or more initial transport addresses and communicates with them in round robin fashion on each action (though most actions will probably be "two hop" operations).

// on startup

Client client = new TransportClient()
        .addTransportAddress(new InetSocketTransportAddress("host1", 9300))
        .addTransportAddress(new InetSocketTransportAddress("host2", 9300));

// on shutdown

client.close();

Note that you have to set the cluster name if you use one different than "elasticsearch":

Settings settings = ImmutableSettings.settingsBuilder()
        .put("cluster.name", "myClusterName").build();
Client client =    new TransportClient(settings);
//Add transport addresses and do something with the client...

Or using elasticsearch.yml file as shown in Node Client

The client allows to sniff the rest of the cluster, and add those into its list of machines to use. In this case, note that the IP addresses used will be the ones that the other nodes were started with (the "publish" address). In order to enable it, set the client.transport.sniff to true:

Settings settings = ImmutableSettings.settingsBuilder()
        .put("client.transport.sniff", true).build();
TransportClient client = new TransportClient(settings);

Other transport client level settings include:

ParameterDescription

client.transport.ignore_cluster_name

Set to true to ignore cluster name validation of connected nodes. (since 0.19.4)

client.transport.ping_timeout

The time to wait for a ping response from a node. Defaults to 5s.

client.transport.nodes_sampler_interval

How often to sample / ping the nodes listed and connected. Defaults to 5s.