Reload the configuration dynamicallyedit

Warning

This functionality is in beta and is subject to change. The design and code is considered to be less mature than official GA features. Elastic will take a best effort approach to fix any issues, but beta features are not subject to the support SLA of official GA features.

You can configure Auditbeat to dynamically reload configuration files when there are changes. To do this, you specify a path (Glob) to watch for module configuration changes. When the files found by the Glob change, new modules are started/stopped according to changes in the configuration files.

To enable dynamic config reloading, you specify the path and reload options in the main auditbeat.yml config file. For example:

auditbeat.config.modules:
  path: ${path.config}/conf.d/*.yml
  reload.enabled: true
  reload.period: 10s
path
A Glob that defines the files to check for changes.
reload.enabled
When set to true, enables dynamic config reload.
reload.period
Specifies how often the files are checked for changes. Do not set the period to less than 1s because the modification time of files is often stored in seconds. Setting the period to less than 1s will result in unnecessary overhead.

Each file found by the Glob must contain a list of one or more module definitions. For example:

auditbeat.modules:

- module: audit
  metricsets: [file]
  file.paths:
    wordpress:
    - /www/wordpress
    - /www/wordpress/wp-admin
    - /www/wordpress/wp-content
    - /www/wordpress/wp-includes
Note

On systems with POSIX file permissions, all Beats configuration files are subject to ownership and file permission checks. If you encounter config loading errors related to file ownership, see http://www.elastic.co/guide/en/beats/libbeat/master/config-file-permissions.html.